Replica Hublot King Power Oceanographic 4000 Price

Hublot King Power Oceanographic 4000 731.NX.1190.RX is a icnoic watch which goes beyond the limit, completely subvert the imagination.Hublot King Power Oceanographic 4000 both in the design, development and manufacturing and other aspects have reached the extreme. As a diving watch, it not only can withstand the pressure from the depths of 4000 meters, and to meet the Swiss watch international standards (NIHS) harsh regulatory requirements. Check replica Hublot King Power Oceanographic 4000 price.

Replica Hublot King Power Oceanographic 4000 Price
Replica Hublot King Power Oceanographic 4000 Price

To test its seal, the Hublot watch was housed in a sealed box-type sink and pressurized to a pressure equivalent to a depth of 5,000 meters. To ensure its water resistance and extreme pressure resistance under the state, sapphire crystal is only 6.5mm thick, although slightly thicker than the average watch mirror, but for the 4000 meters underwater pressure is just right. In order to successfully reach this depth, the back of the watch screw into the necessary conditions, and by the extremely hard two titanium metal, absolutely anti-corrosion. In addition to the titanium metal series, Hublot King Power Oceanographic 4000 also introduced all-black carbon fiber material. Therefore, although the diameter is 48mm, the appearance of the powerful “King Power Oceanographic 4000”, but still feel relaxed to wear.

To ensure that in the deep dark environment, within 25cm distance reading time is still clearly visible, “deep sea Quest 4000 meters” dial, raised and the pointer is a large area to use SuperLuminovaTM luminous coating, which is attached to the titanium metal elements Can send green cold light material. Taking into account the safety control of the dive time, a single rotation of the internal gear drive dive timer, is installed in the distance from the dial as close as possible to avoid the dive neglect of the diving time control, but also more convenient to calculate the dive time The According to the uniform standard, King Power Oceanographic 4000 minute hand scale every 5 minutes are marked out.

The watch is fitted with two crowns with an embedded screw (O-type gasket to ensure that it can withstand deep water pressure). The three-dimensional crown for setting the dive time is set at the two o’clock position to facilitate the user to adjust the setting. Taking into account the safety of divers, the device also has a card and can be wrapped around the protection of the crown, easy to operate while diving while also enhancing its safety. Used for the winding and adjusting the time of another crown, is set at 4 o’clock position, to avoid the operation caused by mistakes.

As a diving watch, the replica Hublot King Power Oceanographic 4000 is specifically equipped with a helium valve to ensure that it can sneak into the depths of 4000 meters. In the diving process, the helium valve to ensure that the process of diving in the infiltration of the gas inside the watch in the process of smooth discharge. The valve is made of corrosion-resistant steel, is located in the left side of the ear, that is, 10 o’clock position. This watch is equipped with two sets of strap, pin strap and buckle strap (for “city version” and “diving version”). This strap is more secure than folding buckles and is easier to handle when wearing gloves.